Question 1: From Harry: How can I prevent Camellia from becoming all gummy. After letting a plane set for a few weeks that had been wiped down with Camellia Oil it was next to impossible to get the plane apart. I actually caused some minor damage it was stuck so hard.
Rollie’s answer: On tools if you have areas that the oil is applied to that don’t see use it can build a bit, but not much and over a long period of time. A quick wipe with a bit of naphtha or acetone will clean it off. Those solvents are essential because they are fully volatile and won’t leave any oily residue, which mineral spirits will do.
Question 2: From Mike: In in a couple months I will be building a house and I will be putting my shop in the basement. Currently I have a small shop, but in my new shop it will be large (about 25x35). Since I have this rare opportunity, I want to put power in the floor and dust collection the floor. Therefore, I have to decide where to put my tools and I will not be able to move them. Are there general guidelines on placement of tools? How far should a table saw be away from a wall? What about a bandsaw, how far from a wall or in the sides? Same question for a router table, jointer and thickness planer.
- Grizzly’s online shop-layout planner
- A Layout Kit for Small Shops by John Yurko #174–Tools & Shops 2004 Issue
Segment: All-Time Favorite Technique
Mike: Using a bendy stick to hold in moldings as you glue them
Ben: Using blue tape and CA glue as a stand-in for double-sided tape
Mike’s double-down technique: Using a bendy ruler clamped in a pipe clamp as a curve bow
From Chris: Do those of you with kids suffer like I do from a never ending queue of fix it items that are piled on the workbench and take precedence over projects? It’s fun to hack together solutions for beloved toys, and see the delight on their faces when it works, but it sucks up most of my limited shop time. Any tips on quick fixes, or do I just need to wait this period out until they are teenagers?
From Jim: I recently upgraded table saws with a killer deal on a used Delta Unisaw with a Unifence. I'm used to a Biesemeyer fence, and have a number of jigs utilizing the parallel faces of the fence, such as an L fence. I do not think I can use these jigs on the Unifence because it lacks the parallel faces necessary to track or clamp the jigs. Any ideas for Unifence modification or other tricks to increase the utility of the Unifence?
Every two weeks, a team of Fine Woodworking staffers answers questions from readers on Shop Talk Live, Fine Woodworking‘s biweekly podcast. Send your woodworking questions to email@example.com for consideration in the regular broadcast! Our continued existence relies upon listener support. So if you enjoy the show, be sure to leave us a five-star rating and maybe even a nice comment on our iTunes page.